Publications

by Keyword: Grinding


By year:[ 2021 | 2020 | 2019 | 2018 | 2017 | 2016 | 2015 | 2014 | 2013 | 2012 | 2011 | 2010 | 2009 | 2008 | 2007 | 2006 | 2005 ]

Minguela, J., Slawik, S., Mücklich, F., Ginebra, M. P., Llanes, L., Mas-Moruno, C., Roa, J. J., (2020). Evolution of microstructure and residual stresses in gradually ground/polished 3Y-TZP Journal of the European Ceramic Society 40, (4), 1582-1591

A comprehensive study of progressively ground/polished 3Y-TZP was performed with the aim of better understanding the mechanisms driving the microstructural modifications observed after such procedures, and identifying the processing parameters leading to optimal microstructures (i.e. ageing-protective and damage-free). Gradually ground/polished surfaces were produced, yielding four different topographies of increasing roughness (grades 1–4) and two different textures (unidirectionally, U, and multidirectionally, M). Phase transformation, microstructure and residual stresses were investigated by means of advanced characterization techniques. It was found that low-roughness mildly ground/polished specimens (i.e. 2-M/U) presented a nanometric layer with the ageing-related protective features generally associated with coarsely ground specimens. A lower limit for grain refinement in terms of surface abrasion was also found, in which partial recrystallization took place (i.e. 1-M/U). A mathematical relation was established between average surface roughness (Sa), monoclinic volume fraction (Vm) and surface compressive residual stresses, demonstrating that if the processing parameters are controlled, both Vm and residual stresses can be predicted by the measurement of Sa.

Keywords: Grinding, Microstructure, Phase transformation, Residual stresses, Zirconia


Minguela, J., Ginebra, M. P., Llanes, L., Mas-Moruno, C., Roa, J. J., (2020). Influence of grinding/polishing on the mechanical, phase stability and cell adhesion properties of yttria-stabilized zirconia Journal of the European Ceramic Society 40, (12), 4304-4314

The changes in mechanical properties, hydrothermal degradation and cell adhesion were studied in 3Y-TZP under two different superficial modification patterns (uni- and multidirectional) with a surface roughness ranging from 16 to 603 nm. In this sense, mechanical properties (i.e. hardness, indentation fracture toughness and scratch) and accelerated tests in water steam were measured to evaluate the influence of the surface treatments on the superficially modified layer. Moreover, a detailed characterization through micro-Raman spectroscopy and X-Ray diffraction was performed. Finally, SaOS-2 osteoblasts were used for the evaluation of the cell adhesion behaviour on the surfaces. Overall, ground/polished specimens increased the mechanical properties and ageing resistance of mirror-like polished specimens, although resistance to degradation was maximum at intermediate conditions (Sa ≈ 40−180 nm). The studied surfaces allowed cell attachment, but promoted contact guidance (i.e. cell alignment) only on unidirectionally ground surfaces above Sa = 150 nm.

Keywords: Cell adhesion, Grinding, Hydrothermal degradation, Mechanical properties, Zirconia